Fit the 4 HD-6G/HD-EX shoulder
5.
screws into the 4 holes of the
main controller board, and then
secure the shoulder screws with
the screws provided from the rear
of the PCB.
Connect the flat cable to the main
6.
controller board.
Install the main controller board
7.
into the printer by sliding it into
the guide rails.
Secure the main controller board with the 2 screws.
8.
Reconnect the interface cable to the printer. Plug the power cord into the
9.
AC outlet, and then turn on the printer.
Format the HD-6G/HD-EX from the control panel. See Chapter 4 for
10.
details.
6-17
CHAPTER 6 OPTIONS
Fig. 6-23
Fig. 6-24
Fig. 6-25