Trial Sewing - Brother PE-400D Operation Manual

TRIAL SEWING

CAUTION
– Be aware of the needle at all times while sewing, and keep your hands away from all moving
parts such as the needle, balance wheel and thread take-up lever, otherwise injury may result.
– Do not pull or push the fabric too hard while sewing, otherwise injury may result.
– Never use bent needles. Such needles can easily break, which could result in injury.
6
1
2
1
4
5
2
1. When the machine is turned on, the straight stitch (left) is al-
ways selected.
2. Pass the thread underneath the presser foot and pull it out
from the rear of the machine by about 5 cm.
1 Upper thread
2 5 cm (13/64")
* Sewing can begin without pulling out the bobbin thread.
* Use the J presser foot.
3. While pressing down on the thread and the fabric with your
left hand, turn the balance wheel with your right hand to lower
the needle to the sewing start position.
1 Thread
刺しゅう
前 3
ページ
設 定
記 憶
次
ページ
戻 る
1
25