Other Sources Of Information; Adding A Second Brother Lpr Port - Brother NC-100h Network User's Manual

Multi-protocol print/fax server

Hide thumbs Also See for NC-100h:

Network user's manual (66 pages)

Network user's manual (106 pages)

Table Of Contents

100

101

102

103

Table of Contents

Select the Brother LPR port (the port name you assigned in step

6 of the "Installing the Brother Peer to Peer Software" on page 4-

5) and press Next.

Enter any desired name for the Brother printer and press Next.

For example, you could call the printer "Networked Brother

Printer".

Windows

select Yes and then select Finish.

You have now finished installing the Peer to Peer Print (LPR) software.

Adding a Second Brother LPR Port

You do not re-run the install program to add a new Brother LPR port.

Instead, press the Start button, select Printers and Faxes, and

open the window. Click on the icon of the printer that you wish to

configure, select File from the menu bar, and then choose

Properties. Click on the Details tab and push the Add Port button.

In the Add Port dialog, select the Other radio button and then

highlight Brother LPR port. Click OK and enter the port name. The

default port name is BLP1. If you have already used this name, you

will get an error message if you try to use it again, in which case use

BLP2, etc... Once you have specified the port name, click the OK

button. You will then see the Port Properties dialog.

Enter the IP address of the printer that you wish to print to and click

OK. You should now see the port that you have just created in the

Print to the following port setting of the printer driver.