Brother NC-8100h Quick Network Setup Manual page 4

10. Plug the NC-8100h into connector P1 located on the main board as shown in the illustration. Make sure that
both connectors are firmly together by pushing down the back of the NC-8100h.
11. Fit the two screws into the NC-8100h plate.
12. Refit the metal cover over the main board, inserting it under the flat cable.
13. Refit the two screws into the metal cover.
14. Refit the rear cover.
15. Reconnect the phone lines at the side of the machine.
16. Reconnect any additional interface cables that you removed.
17. Reconnect the power cable.
4