Manual And Automatic Fax Redial; Dual Access; Real Time Transmission - Brother FAX-2800 Owner's Manual

Manual and Automatic Fax Redial

If you're sending a fax manually and the line is busy, press Redial/Pause to
try again. Anytime you want to make a second call to the last number dialed,
press Redial/Pause to save time.
If you're sending a fax automatically and the line is busy, the FAX/MFC will
automatically redial (up to three times at 5 minute intervals).

Dual Access

You can scan up to 50 documents into the fax memory, even while the FAX/
MFC is receiving or sending another fax (from memory). You can set temporary
settings for each fax you're scanning, except Polling.
If you try to scan and store a 51st fax, the FAX/MFC will send it immediately
without storing it in memory.
If you get a OUT OF MEMORY
Note
fax, press Stop/Exit to cancel scanning. If you get a
message while scanning a subsequent page, you'll have the option to press
Fax Start to transmit the pages scanned so far or press Stop/Exit to cancel
the operation.
1
Place the original face down in the ADF.
2
Enter the fax number.
3
Press Fax Start. As the FAX/MFC scans the original, the LCD shows the job
number (#XXX) of the fax and how much memory is available. Then the FAX/
MFC starts dialing. You can immediately repeat Steps 1 to 3 for the next fax.
The number of pages you can scan into memory varies with the data they
contain.

Real Time Transmission

When you are sending a fax, the FAX/MFC will scan originals into memory before
sending them. Then, as soon as the phone line is free, the FAX/MFC will start dialing
and sending the fax. If memory becomes full, the FAX/MFC will send the document
in real time (even if
Sometimes you may want to send an important document immediately, without
waiting for memory transmission. You can set
1
Place the original face down in the ADF.
2
Press Menu/Set, 2, 2, 6.
6 - 3
S E T U P S E N D
message while scanning the first page of a
REAL TIME TX is set to OFF).
OUT OF MEMORY
REAL TIME TX to ON.