Replacing The Corner Cutter Trimmer Tray - Brother LX-1200 Owner's Manual

Replacing the corner cutter trimmer tray

The cutter performance will decline as the blade becomes dull.
You can improve the performance of the blade by replacing the corner cutter trimmer tray.
You can use both sides of the corner cutter trimmer tray. To use the other side simply remove the corner
cutter trimmer tray as shown below and reinsert it with the other side up. Install a new corner cutter trimmer
tray after both sides are worn.
Use the following operation to replace the corner cutter trimmer tray when necessary.
Note
Use Brother authorized cutter units (SC-2 or CC-3) only.
Other cutter units, (top/bottom cutter unit and the upper blade of the corner cutter) are not user
replaceable. Please consult your dealer if these cutter units become dull or damaged.
(9)Close the top cover.
(10)Press the Feed button until you can see the
edge of the film to remove any slack from the
film.
Corner Cutter Trimmer Tray (CC-3)
(1) Remove the corner cutter trimmer tray as
illustrated.
(2) Install the new corner cutter trimmer tray.
- 37 -