Download  Print this page

Advertisement

STEP2
Installing the Driver & Software
Using the SecureEasySetup™ software to configure your machine for a
wireless network
Important
Make sure that you have finished the
instructions from Step 1 Setting Up the
Machine on pages 4 through 15.
The SecureEasySetup™ software allows you to
configure the wireless network easier than
configuring it manually. By pushing a button on the
wireless router or access point, you can complete
setup and secure the wireless network. Your router or
access point must also support SecureEasySetup™.
See the user's guide for your wireless LAN router or
access point for instructions to configure your
machine for a wireless network. If your wireless router
or access point does not support SecureEasySetup™
go to page 44 for installation instructions.
Note
Routers or access points that support
SecureEasySetup™ have the
SecureEasySetup™ symbol as shown below.
1
Turn on the machine by connecting the power
cord.
42
Improper Setup
If you have previously configured the wireless
settings of the machine you must reset the
network (LAN) settings before you can
configure the wireless settings again.
On your machine, press Menu. Press a or b to
choose LAN and then press OK.
Press a or b to choose Factory Reset, and
then press OK. Press 1 twice for Yes to accept
the change.
2
Place the Brother machine close to the
SecureEasySetup™ router or access point
(less than 16 feet/5 m).
3
Push the SecureEasySetup™ button on your
wireless router or access point. See the user's
guide for your wireless router or access point
for instructions.
4
On your machine, press Menu.
Press a or b to choose LAN and press OK.
Press a or b to choose Network I/F and
press OK.
Press a or b to choose WLAN and press OK.
The wired network interface will become
inactive with this setting.
It will take about a minute for the LAN menu on
the LCD to become available again.
5
Press a or b to choose Setup WLAN and
press OK.
Press a or b to choose SecureEasySetup
and press OK.
6
The wireless network connection status using
the SecureEasySetup™ software will be
displayed: Connecting WLAN, Connected
or Connection Error.
Connecting WLAN is displayed when the
print server is trying to make connections to
your router or access point. Wait till either
Connected or Connection Error is
displayed.
Connected is displayed when the print server
is successfully connected to your router or
access point. You can now use your machine
in a wireless network.
®
Macintosh

Advertisement

Table of Contents

   Also See for Brother MFC-665CW

   Related Manuals for Brother MFC-665CW

Comments to this Manuals

Symbols: 0
Latest comments: