Brother MFC-6490CW Quick Setup Manual page 22

Wired Network
c
Carefully route the network cable through the
trench and out the back of the machine. Then,
connect the cable to your network.
Note
If both USB and LAN cables are being used,
guide both cables through the trench with one on
top of the other.
Important
Make sure that the cable does not restrict the
cover from closing, or an error may occur.
d
Gently close the scanner cover using the finger
holds on both sides of it.
WARNING
Be careful not to trap your fingers under the
scanner cover.
Always use the finger holds provided on both
sides of the scanner cover when opening and
closing it.
22
17
Connect the power cord
a
Connect the power cord.
Important
If you have previously set up your machine for
a wireless network and then want to set it up
on a wired network, you should check that the
machine's Network I/F is set to Wired LAN.
The wireless network interface will become
inactive with this setting.
On your machine, press Menu.
Press a or b to choose Network and press OK.
Press a or b to choose Network I/F and
press OK.
Press a or b to choose Wired LAN and press
OK.
Press Stop/Exit.
®
Windows