Technimount System BRACKET PRO 151 Series User Manual page 18

INSTALLATION OF THE BRACKET ONTO THE MAXBLEND2 OXYGEN BLENDER
(CONTINUED)
5. Install the U-block of the main assembly by sliding
it onto the rear block of the medical device.
6. Align the main assembly with the rear block
of the medical device and the U-block already
installed.
7. Install the main assembly at the rear of the
medical device.
8. Align the screws and screw holes from the main
assembly.
9. Install the Four (4) Black-Oxide Stainless Steel
Flat Head Phillips Screws 10-32 x 1/2" with the
U-block (tightening will be at the end).
NOTE
Put a few drops of medium strength thread-locking
adhesive (blue Loctite 242) on each screw before
installation to prevent the screws from loosening
during normal use.
18
INSTALLATION GUIDE
BP151 UG 202108-01 www.technimount.com