Selecting Your Country (Not Language); Selecting Your Language - Brother DCP-8040 Quick Setup Manual

Selecting Your Country
6
(Not Language)
Norway, Sweden, Finland and Denmark only.
You must set your country so that the DCP works
correctly. (This function is not available on UK, Asia
and Oceania machine.)
1
Check that the power is turned on by
plugging in the power cord and turn the
power switch on.
Press Set.
Set Country
Press Set Key
2
Press or
(NORWAY, SWEDEN, FINLAND or
DENMARK). (Make sure you set your
country, not your language.)
Set Country
▲ Norway
Sweden
▼ Finland
Select ▲▼ & Set
3
Press Set when the LCD shows your
country.
4
The LCD prompts you to make sure of the
country again.
Set Country
Norway
1.Yes
2.No
Enter Number
5
If the LCD shows the correct country, press
6
1 to go to Step .
—OR—
Press 2 to go back to Step
country again.
to select the country
1
to select the
6
After the LCD shows
seconds, it shows
Vennligst
Set Country
Norway
1.Yes
2.No
Accepted
If you select "NORWAY" in step
shows Norwegean messages.
7
After the LCD returns to the copy mode, turn
the power switch off, and then turn it on
again.
7

Selecting Your Language

You can change LCD Language. (This function is not
available on UK, Asia and Oceania machine.)
1
Press the Menu key.
2
Press the key.
3
Press the key.
4
Press or
language, and then press the Set key.
5
Press the Stop/Exit key.
Go to Next page to
install the driver
for two
Accepted
vent.
4
, the LCD
to select your
5