Release The Scanner Lock; Install The Power Cord - Brother DCP-8040 Quick Setup Manual

Step 1
3
Fan the stack of paper well to avoid paper
jams and misfeeds.
4
Put paper in the paper tray.
Check that the paper is flat in the tray and
below the maximum paper mark.
5
Put the paper tray firmly back in the DCP and
unfold the Support flap before you use the
DCP.
Support
Flap
For details on supported paper
specifications, see "Paper" in Chapter 2 of
the User's Guide.
4
Setting Up the Machine
Up to here.
Release the Scanner
4
Lock
1
Push the lever up to unlock the scanner.
(The gray scanner lock lever is located at
the back left under side of the document
cover.)
Scanner Lock Lever
5

Install the Power Cord

Do not connect the Parallel or USB
cable yet.
1
Make sure that the power switch is off.
Connect the AC power cord to the DCP.
2
Plug the AC power cord into an AC outlet.
Turn the power switch on.
If
Check Scan Lock
immediately release the scanner lock and
press Stop/Exit.
appears on the LCD,