Macintosh; For Usb Interface Users (For Mac Os ® X 10.2.4 Or Greater) - Brother DCP-330C Quick Setup Manual

Installing the Driver & Software
For USB Interface Users
(For Mac OS
Important
Make sure that you have finished the
instructions from Step 1 Setting Up the
Machine on pages 4 through 11.
Note
®
For Mac OS X 10.2.0 to 10.2.3 users, upgrade to
®
Mac OS X 10.2.4 or greater. (For the latest
information for Mac OS
http://solutions.brother.com)
1
Using both hands, use the plastic tabs on both
sides of the machine to lift the scanner cover
until it locks securely into the open position.
2
Insert the USB cable into the USB socket
marked with a
USB socket inside the machine as shown
below.
®
X 10.2.4 or greater)
®
X, visit
symbol. You will find the
3
Carefully route the USB cable through the
trench and out the back of the machine as
shown below and connect the cable to your
computer.
Improper Setup
• DO NOT connect the machine to a USB port on
a keyboard or a non-powered USB hub.
Brother recommends that you connect the
machine directly to your computer.
• Make sure that the cable does not restrict the
cover from closing, or an error may occur.
4
Lift the scanner cover to release the lock (
Gently push the scanner cover support
down ( ) and close the scanner cover ( ).
5
Turn on the machine by connecting the power
cord.
®

Macintosh

).
21