Cleaning The Corona Wire - Brother DCP 7065DN Advanced User's Manual

Note
In addition to cleaning the scanner glass
and glass strip with a soft lint-free cloth
moistened with water, run your finger tip
over the glass to see if you can feel
anything on it. If you feel dirt or debris,
clean the glass again concentrating on
that area. You may need to repeat the
cleaning process three or four times. To
test, make a copy after each cleaning.
d
Plug the machine's power cord back into
the AC power outlet first, connect all
cables, and then plug in the telephone
line cord. Turn on the machine's power
switch.

Cleaning the corona wire

If you have print quality problems, clean the
corona wire as follows:
a
Open the front cover and leave the
machine turned on for 10 minutes to
cool down.
WARNING
HOT SURFACE
After you have just used the machine, some
internal parts of the machine will be
extremely hot. When you open the front or
back cover (back output tray) of the
machine, DO NOT touch the shaded parts
shown in the illustration. If you do this, you
may get burned.
16
A
b
Slowly take out the drum unit and toner
cartridge assembly.
CAUTION
We recommend that you place the drum
unit and toner cartridge assembly on a
clean, flat surface with a sheet of
disposable paper or cloth underneath it in
case you accidentally spill or scatter toner.