Table 8-1. Unit Access Table Commands - ADTRAN TDU 120e User Manual

Command
Add New Unit
Modify Unit
Delete Unit
Default Unit
Passcode
OK
61202156L2-1A
The following chart describes each command of the Unit
Access Table.
What it does...
Adds a new device to the table.
You must enter a device Unit ID, passcode, Unit type, and polled
flag. Unit type can be:
Standard (which supports any TSU/TDU Multiplexer and the ISU
512), or TSU Standalone (a single port TSU with no option card slot).
A passcode of 0 to 9999 for each device or
selected, which results in the default passcode being used (defined
as 0022 in Figure 8-1 on page 8-2).
Traps are normally sent from the unit in alarm to the TDU 120e. For
units in the Unit Access Table that are not chained directly to the
TDU 120e but are managed over Inband or the FDL, traps are not
automatically forwarded. Polling must be enabled on the TDU 120e
for these units in order to receive Traps on the NMS. The TDU 120e
can be configured to poll selected units for traps by enabling the
polled option when adding or modifying a unit entry.
Allows unit ID, passcode, device type, and polled flag to be changed
for an existing entry in the table.
Deletes an entry in the table.
Sets the default passcode for all devices in the table that have
DEFAULT
passcodes set to
C
Returns to the
ONFIGURE
TDU 120e User Manual
Chapter 8. Remote/Management Menus

Table 8-1. Unit Access Table Commands

, or for any unit not listed in the table.
A
menu.
GENT
DEFAULT
may be
8-3