Tray Use In Copy Mode (Mfc-5860Cn Only); Volume Settings; Ring Volume; Beeper Volume - Brother MFC-5460CN User Manual

Chapter 3
Tray use in Copy mode
(MFC-5860CN only)
You can change the default tray the machine
will use for printing copies.
If both trays are set to the same size and type
of paper, Auto Select will let your machine
take from Tray#1 first, then take from Tray#2
if Tray#1 runs out of paper.
To change the default settings follow the
instructions below:
a
Press Menu, 1, 8.
b
Press a or b to choose Tray#1 Only,
Tray#2 Only or Auto Select.
Press OK.
c
Press Stop/Exit.
Note
You can only use plain paper sizes Letter,
Legal or A4 in Tray#2.
24

Volume Settings

3

Ring Volume

You can choose a range of ring volume
levels, from Off to High.
While in Fax mode
to adjust the volume level. The LCD shows
the current setting, and each key press will
change the volume to the next level. The
machine will keep the new setting until you
change it.
You can also change the volume through the
menu, by following the instructions below:
Setting the Ring Volume from the
menu
a
Press Menu, 1, 4, 1.
b
Press a or b to choose Off, Low, Med
or High.
Press OK.
c
Press Stop/Exit.

Beeper Volume

When the beeper is on, the machine will beep
when you press a key, make a mistake or
after you send or receive a fax.
You can choose a range of volume levels,
from Off to High.
a
Press Menu, 1, 4, 2.
b
Press a or b to choose Off, Low, Med
or High.
Press OK.
c
Press Stop/Exit.
3
3
, press d or c
3
3