RH-21
Troubleshooting
Error
Description
C101
"The Phone does not set FbusTx line high after the star-
tup."
C102
"The Phone does not set FbusTx line low after the line
has been high. The Prommer generates this error also
when the Phone is not connected to the Prommer."
C103
"Boot serial line fail."
C104
"MCU ID message sending failed in the Phone."
C105
"The Phone has not received Secondary boot codes
length bytes correctly."
Page 26
Table 2: Flash programming error codes
Nokia Corporation Confidential
CCS Technical Documentation
Not working properly
Vflash1
VBatt
BSI and FbusRX from prommer to UEM.
FbusTx from UPP->UEM->Prom-
mer(SA0)
PURX(also to Safari)
VR3
Rfclock(VCTCXO->Safari->UPP)
Mbus from Prommer->UEM-
>UPP(MbusRx)(SA0)
FbusTx from UPP->UEM->Prom-
mer(SA1)
BSI and FbusRX from prommer to UEM.
Mbus from Prommer->UEM-
>UPP(MbusRx)(SA1)
FbusRx from Prommer->UEM->UPP
FbusTx from UPP->UEM->Prommer
FbusTx from UPP->UEM->Prommer
Mbus from Prommer->UEM-
>UPP(MbusRx)
FbusRx from Prommer->UEM->UPP
FbusTx from UPP->UEM->Prommer
Issue 1 05/2003