Table of Contents
Advertisement
58
C H A P T E R S I X
See
"One Touch
and Speed
Dial"
chap. 7
Fax Redial
If you're sending a fax manually and the line is busy, you can retry the
number by pressing Redial/Pause.
1
Press Redial/Pause.
2
Press Start. (Only for Ireland)
If you're sending a fax automatically and the line is busy, the machine
will automatically redial up to 4 times (3 times for Ireland) at 2 minute
intervals.
Dual Access
You can scan up to 50 messages into the fax memory, even while the
machine is receiving or sending another fax (from the memory). You can
set temporary settings for each fax you're scanning, except Timer and
Polling.
If you try to scan in and store a 51st fax, the machine will send it
immediately, without storing it in memory.
If you get a MEMORY FULL message while scanning the first page of
a fax press Stop to cancel a scan. If you get a MEMORY FULL
message while scanning in a subsequent page, you'll have the option to
press Start to transmit the pages scanned so far, or to press Stop to
cancel the operation.
1
Make sure the document feeder is empty.
2
Place the document in the feeder.
3
Enter the fax number
4
Press Start. The machine starts scanning the document and the
screen displays the job number (#XX) of the fax, and how much
memory is available. When the machine starts dialling you can
immediately repeat steps 1 through 4 for the next fax.
Real Time Transmission
When memory is full, the machine cannot continue to scan documents
into memory before sending. However, you can turn on REAL TIME
TX. Then place the documents in the feeder and enter the fax number.
As soon as the phone line is free, the machine starts dialling and sending
the fax.
1
Place the document in the feeder.
Advertisement
Table of Contents
