Greenlee HFC30 Instruction Manual page 4

IMPORTANT SAFETY INFORMATION
The valve may be hot during and
after operation. Use care not to
touch the body of the valve. Hot
surfaces can cause serious burns.
Hydraulic oil can cause skin irritation.
• Handle the tool and hoses with care to prevent
skin contact with hydraulic oil.
• In case of accidental skin contact with hydraulic
oil, wash the affected area immediately to remove
the oil.
Failure to observe these precautions can result in
injury.
Greenlee Tools, Inc.
HFC30 Flow Control Valve
• Inspect the valve every operating day. Repair or
replace if leakage, cracking, wear or damage is
evident. A damaged valve can fail, resulting in
injury or property damage.
• Use this tool for manufacturer's intended purpose
only. Use other than that which is described in this
manual can result in injury or property damage.
Procedure for connecting or disconnecting hydraulic
hoses, fittings or components:
1. Move the flow lever on the power source to the
OFF position.
2. Stop the hydraulic power source.
3. Follow the sequence under Hose Connections to
prevent pressure buildup. In case some pressure
has built up, loosen hoses, fittings or compo-
nents slowly.
Notes:
(1) Keep decals clean and legible. Replace when
necessary.
(2) When disposing of any components (hydraulic
hoses, hydraulic fluid, worn parts, etc.), do so in
accordance with federal, state and local laws or
ordinances.
4
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070