Model And Serial Number Location; Check Operation - Electrolux ECCG3668AS Installation Instructions Manual

GAS COOKTOP INSTALLATION INSTRUCTIONS
Do not, under any circumstances, cut or remove the
third (ground) prong from the power cord.
Disconnect electrical supply cord from
wall receptacle before servicing cooktop.
Preferred Method
Grounding type
wall receptacle
Figure 9

Model and Serial Number Location

The serial plate is located on the underside of the
cooktop (see Figure 10).
When ordering parts for or making inquires about your
range, always be sure to include the model and serial
numbers and a lot number or letter from the serial plate
of your cooktop.
Your serial plate also tells you the rating of the burners,
the type of fuel and the pressure the cooktop was
adjusted for when it left the factory.
Figure 10

Check Operation

Refer to the Use and Care Guide packaged with the
appliance for operating instructions and for care and
cleaning of your cooktop.
Do not touch the burners. They may be
hot enough to cause burns.
1. Check Burner Cap Placement
Regular burner
It is very important to be sure that all surface burner
caps and burner grates are properly installed and in
the correct locations before operating the appliance.
(For 30" & 36" Models)
Do not, under any
circumstances, cut,
remove, or bypass
the grounding
prong.
Power supply cord with
3-prong grounding plug.
Serial plate is
located under
the burner box.
The cooktop is not removeable. Do not attempt to
remove or lift the cooktop.
To prevent flare-ups and avoid creation
of harmful by-products, do not use the cooktop without
all burner caps properly installed to insure proper
ignition and gas flame size.
Always keep the burner caps and burner heads in
place whenever the surface burners are in use. Do not
allow spills, food, cleaning agents or any other material
to enter the gas orifice holder openings.
Check and be sure the size of each burner cap
matches the size of the burner head. Check and be
sure that all round style burner caps are correctly in
place on round burner heads.
Check and be sure that all oval style burner caps are
correctly in place on oval burner heads (if equipped).
Check and be sure that all dual or twin style burner
caps are correctly in place on dual or twin burner
heads (if equipped).
On round style burners, the burner cap should fit
snug into the center of burner head and be level.
Refer to Figure 11 for correct and incorrect burner cap
placement.
Once in place, you may check the fit by gently sliding
the burner cap from side to side (Fig. 12) to be sure
it is centered and firmly seated. Please note that the
burner cap should NOT move off the center of the
burner head when sliding from side to side.
Orifice
Holder
Ignitor
8
Burner
Cap
Burner
Head
Ignitor
Orifice
Holder
Figure 11