Opening The Synth - Clavia nord lead 2X Service Manual

Opening the synth

WARNING: Take necessary precautions against ESD before opening the synth.
Nord Lead 2X
Loosen the screws as shown in
the figure. (9x40018)
The two screws on the sides
work as hinges. Lift in the front
to open the top.
Nord Lead 2
(8x40018)
Nord Rack 2/2X
Unscrew the 4 panel screws
Gently slide the top
(40018)
forward and lift it of.
Removing the Power Supply Unit
Loosen the five screws
on the back panel next to the AC socket. Finally remove the 10 pole ribbon cable
(40013)
and lift out the PSU.
(22340)
Removing the Main Board
Loosen the three screws
and remove the washers around the ¼" jacks on the back panel. Also loosen the four
screws holding the MIDI jacks to the chassis. Remove the 20 pole ribbon cable
(40010)
to the panel board, the 10 pole ribbon cable
(22400)
ribbon cables
(22290)
You can now lift out the main board.
Removing the Panel Board
Pull off all knobs
(22900)
from the panel board. Loosen the last two screws
(22400)
chassis. Loosen the nine screws
You can now lift out the panel board.
Clavia DMI
holding the PSU to the chassis. Loosen the two screws
(40262)
holding the main board to the chassis. Loosen the nuts
(40262)
to the keyboard.
on the front panel (not the buttons). Remove the ribbon cable
(40262)
Service manual Nord Lead 2x rev. 1.1
Picture shows Nord Lead 2X
to the PSU and the two
(22430)
(40018)
holding the panel board to the upper lid.
holding the top to the
Page 7