Casio DT-X8 Series Software Manual page 54

Hide thumbs Also See for DT-X8 Series:
Table of Contents

Advertisement

2.2.5 Scan Result Notification
When scanning a bar code is complete, a notification about the scanning result can be indicated to
the user via either LED or buzzer. Each indication method can be set to "Enable" or "Disable".
Table 2.44
Indication
method
LED
Buzzer
Vibrator
Notes:
1. Scanning fails when one of the errors occurs.
• A bar code with the number of digits which exceeds over the specified range is scanned.
• Check digit calculation error occurs.
2. Full ASCII conversion error occurs in scanning bar code of Code39 symbology or Code128
symbology.
3. If the "OBR buffer output" method has been set effect as scanned data output method, the
condition occurs if scanning takes place while data for 9 labels are stored already in the OBR
buffer.
The functions of the Laser Scanner Library relevant to the "Scan Result Notification" are as
follows.
OBRSetLED
OBRGetLED
OBRSetBuzzer
OBRGetBuzzer
When
Setting
succeeded
Mode 1
ON in green
Mode 2
ON in green
Mode 3
None
(Disable)
Enable
Scan
completion
sound
Disable
None
Enable
Vibration
Disable
None
: Sets up LED notification.
: Retrieves the status of LED notification.
: Sets up buzzer notification.
: Retrieves the status of buzzer notification.
Scanning
When failed
interrupted
(note 1)
(Trigger key
released)
None
None
ON in red
None
None
None
None
None
None
None
None
None
None
None
54
OBR buffer
full
Default
(note 2)
ON in green
Mode 1
ON in green
None
Warning
Enable
sound
None
None
Disable
None

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dt-x8-10eDt-x8-10c-cnDt-x8-20eDt-x8-20c-cn

Table of Contents