Casio IT-G500 Series Software Manual page 56

Hide thumbs Also See for IT-G500 Series:
Table of Contents

Advertisement

(5) Setting unique specialized operation symbology
The terminal can be set to perform special actions when various barcode symbologies are scanned
and satisfy certain conditions. The code types, conditions, and operation content are as follows.
Barcode
Code128
*1 FNC2 for Code128 is an identifier that indicates linked barcodes. Even if a Code128 including
FNC2 is read, the scanner cannot output data as soon as it is read. After that, when a Code128
not including FNC2 is read, the data read up to that time is linked and output. The size of
combined symbol data is limited to 98 characters. If this is exceeded, the previous combined
symbol data that was scanned right before the exceeded combined symbol data are output.
*2 When using the trigger keys to scan barcodes which include FNC2,
Read one barcode with one scan operation on laser scanner models. The laser goes out after a
barcode is read, so scan each barcode individually. Finally, output the results after scanning a
barcode that does not include FNC2.
Conditions
When barcode data
includes FNC2
When barcode data
includes FNC4
When the lead character is
FNC1
When the character is
FNC1
When the third or later
character is FNC1
Scanned barcode data including the FNC2
function character is temporarily stored in the
scanner. The stored data can be automatically
added at the forefront of the subsequent scanned
symbol data to be output.
*1, *2
128 can be added to the ASCII value of the single
data character that follows after FNC4, and the
result output as an extended ASCII character. If
two sequentialFNC4 function characters are
scanned, either a group of two sequential FNC4
function characters are read, or "128" is added
automatically to each subsequent ASCII character
data following the two FNC4 characters until the
end of the symbol.
The scanned barcode is recognized as a GS1-128
(EAN128) code. The single data character that
follows after the lead FNC1 can be output as a
character GS(1DH).
The FNC1 character is not output.
The single data character that follows after FNC1
can be output as a character GS(1DH).
56
Operation

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents