Haier HW80-BP16636 User Manual page 10

3-Control panel
3-9
Steam
3-10
Extra rinse
3-11
Extra rinse
Speed up
3-12
Delay
Note: Liquid detergent
If using liquid detergent, it is not recommended to activate the end time delay.
3-13
Start/Pause
3-14
Temp. Speed
3-15
10
If "Temp." button is pushed the "Steam" function will
be deactivated.You can activate "Steam" function only
before to start any programme. You cannot activate
"Steam" function while the appliance is already ex-
ecuting a programme.
3.5.4 Function button"Extra rinse"
Press this button (Fig. 3-10) to rinse the laundry more
intense with fresh water. This is recommended for
people with sensitive skin.
By pressing the button several times one to three ad-
ditional cycles can be selected. They appear in the dis-
play with //.
3.5.5 Function "Speed up"
This function saves time and energy. Preferable if laun-
Delay
dry is slightly soiled. Press simultaneously button „Ex-
tra rinse." and "Delay" (Fig. 3-11) for about 3 seconds
to activate the "Speed up" function;  u is dis-
played. This function is not available in all programmes
(see PROGRAMMES).
3.6 "Delay" button
Press this button (Fig. 3-12) to start the programme
with a delay. End time delay could be increased in steps
of 30 minutes from 0,5-24h. For example display off
: means end of programme cycle will be in 6 hours
and 30 minutes. Press "Start/Pause" button to activate
the time delay. It is not applicable to programme SPIN.
3.7 „Start/Pause" button
Press this button (Fig. 3-13) gently to start or inter-
rupt the currently displayed programme. During pro-
gramme setting and during programme run the LED
above the button is shining, or if interrupted blinking.
3.8 Child lock
Steam
Press button „Temp." and "Steam" (Fig. 3-14) for 3
seconds simultaneously to block all panel elements
against activation. For unlocking please press again
the two buttons.
The display shows 
pressed, when the child lock is activated. The change
is not running.
(Fig. 3-15) if a button will be
 
GB