Brother MFC MFC-5460CN User Manual page 122

Error Message Cause
Data Remaining Print data is left in the machine's
memory.
Print data is left in the machine's
memory. The USB cable was
unplugged while the computer was
sending the data to the machine.
The other person or other person's
Disconnected
fax machine stopped the call.
The document was not inserted or
Document Jam
fed properly, or the document
scanned from the ADF was too
long.
The machine is set to Distinctive
DR Mode in Use
Ring mode. You cannot change the
Receive Mode from Manual to
another mode.
The print head is too warm.
High Temperature
Init. Unable XX The machine has a mechanical
problem.
—OR—
A foreign objects such as a clip or
ripped paper is in the machine.
One or more of the ink cartridges is
Ink Empty
empty. The machine will stop all
print operations. While memory is
available, black and white faxes will
be stored in the memory. If a
sending machine has a color fax,
the machine's
that the fax be sent as black and
white. If the sending machine has
the ability to convert it, the color fax
will be stored in the memory as a
black and white fax.
Low Temperature The print head is too cold.
The media card is either corrupted,
Media Error
improperly formatted, or there is a
problem with the media card.
106
Action
Re-start printing from your computer.
Press Stop/Exit. The machine will cancel the job
and clear it from the memory. Try to print again.
Try to send or receive again.
See Using the ADF on page 10.
See Document jam on page 109.
Set Distinctive Ring to off. (See Turning off
Distinctive Ring on page 43.)
Allow the machine to cool down.
Open the scanner cover and remove any foreign
objects inside the machine. If the error message
continues, see Transferring your faxes or Fax
Journal report on page 108 before disconnecting
the machine so you will not lose any important
messages. Then, disconnect the machine from
the power for several minutes and then reconnect
it.
Replace the ink cartridges. (See Replacing the
ink cartridges on page 113.)
' '
handshake will ask
Allow the machine to warm up.
Put the card firmly into the slot again to make
sure it is in the correct position. If the error
remains, check the media drive by putting in
another media card that you know is working.