Photo Frame - Sony DPF-V1000 Operating Instructions Manual

Symptom
Cannot delete an
image.
An image was
deleted
accidentally.
Connecting a digital camera or other external device
Symptom
The camera is
connected but
nothing is
displayed.
Nothing happens
even if the USB
cable is
disconnected and
then re-connected.
Images are not
displayed on the
TV screen or LCD
screen.

Photo frame

Symptom
Nothing happens
even if you operate
the photo frame.
GB
76
Check item
• Is the memory card write-
protected?
• Is the write-protect switch of
the memory card in the
[LOCK] position?
• Are you using a "Memory
Stick-ROM"?
• Is this image protected?
—
Check item
• Is the cable connected
properly?
• Is the photo frame turned
on?
—
• Is the input of the TV set to
external input?
Check item
—
Cause/Solutions
c Use the device you are using to cancel
write-protection and try deleting again.
c Slide the write-protect switch to the
enable position.
c It is not possible to delete an image from
or format a "Memory Stick-ROM".
c Check the image information from the
single view mode. (.page 33)
c An image with a
Only. You cannot delete it on the photo
frame.
c An image cannot be recovered once it is
deleted.
Cause/Solutions
c Connect the cable properly.
c Turn both the photo frame and the camera
to ON.
c An over current error may have occurred
with the photo frame. To recover from the
error, turn the power of the photo frame
off and then back on.
c Even if the input of the TV is not set to the
photo frame, images may sometimes not
be displayed on the TV screen or LCD
screen if an HDMI cable is connected.
c Change the input of the TV to the photo
frame, or disconnect the HDMI cable and
switch the display to the LCD screen.
Cause/Solutions
c Push the reset switch on the back of the
photo frame using a long, thin object such
as a pin, etc. (.page 13)
mark is set to Read