Surface Burners - Whirlpool W11508802B Control Manual

Table of Contents

Advertisement

Available languages

Available languages

KEYPAD
FEATURE
START TIME
Delayed start
COOK TIME
Timed
cooking
PRECISE CLEAN
Self-cleaning
cycle
START hold 3 sec. to
Oven control
lock
lockout
SETTINGS
Oven use
functions

Surface Burners

NOTE: Do not obstruct the flow of combustion and ventilation air
around the burner grate edges.
Always keep the burner cap in place when using a surface burner.
A clean burner cap will help avoid poor ignition and uneven
flames. Always clean the burner cap after a spillover, and routinely
remove and clean the caps according to the "General Cleaning"
section in the Owner's Manual.
Alignment: Be sure to align the gas tube opening in the burner
base with the orifice holder on the cooktop and the igniter
electrode with the notch in the burner base.
A. Burner cap
B. Gas tube opening
C. Burner base
NOTE: The oval burner base is permanently attached to the
burner cap.
Gas tube opening: Gas must flow freely throughout the gas tube
opening for the burner to light properly. Keep this area free of soil
and do not allow spills, food, cleaning agents or any other material
to enter the gas tube opening. Keep spillovers out of the gas tube
opening by always using a burner cap.
A. 1-1
1
/
" (2.5-3.8 cm)
2
B. Burner ports
INSTRUCTIONS
The Start Time keypad is used to enter the starting time for an oven function with a
delayed start. Start Time should not be used for foods such as breads and cakes because
they may not bake properly. To set a Timed Cook or a Delayed Timed Cook, see the "Cook
Time" section.
Cook Time allows the oven to be set to turn on at a certain time of day, cook for a set
length of time, and/or shut off automatically. To set a Cook Time or Delayed Cook Time,
see the "Cook Time" section.
NOTE: If cooking in both ovens, press any number on the keypad, then follow the
on-screen prompts to select the desired oven before entering temperature.
See the "Self-Cleaning Cycle" section in the Owner's Manual.
1. Check that the ovens and timers are off.
2. Press and hold START for 3 seconds.
3. If enabled, a tone will sound and "CONTROL LOCKED" will be displayed.
4. Repeat to unlock. No keypads will function with the controls locked.
Enables you to personalize the audible tones and oven operation to suit your needs. See
the "Oven Use" section.
D. Igniter electrode
E. Orifice holder
To Clean:
IMPORTANT: Before cleaning, make sure all controls are OFF
and the cooktop is cool. Do not use oven cleaners, bleach, or
rust removers. Do not wash in the dishwasher
1. Remove the burner cap and the burner base, and clean
according to "General Cleaning" section in the Owner's
Manual.
2. Clean the gas tube opening with a damp cloth.
3. Clean clogged burner ports with a straight pin as shown.
Do not enlarge or distort the port. Do not use a wooden
toothpick. If the burner needs to be adjusted, contact a trained
repair specialist.
4. Replace the burner base. The burner bases and caps must be
properly positioned before cooking. Your range comes with
three sizes of burners and caps. See the following illustration
for burner positions.
A. Small (AUX)
B. Large (UR)
C. Oval
D. Medium (SR)
E. Large (UR)
3

Advertisement

Table of Contents
loading

Table of Contents