Electrolux ETB2302J-A User Manual page 34

34 www.electrolux.com
Crisper operation
CONCERN
Excess moisture build up in
crisper
It is normal for there to be some
moisture and humidity in the
crisper bin.
Crisper bin can not be removed
Freezing items in the crisper
Automatic Ice maker system
CONCERN
Ice maker does not produce ice
or not enough ice
The icemaker is designed to
produce a tray of ice
approximately every 2 hours,
depending on the conditions.
Ice has bad odour or taste
If you still require service
If you have a problem, and the problem persists after you have made the checks mentioned, contact your
nearest Electrolux approved Service Centre or the dealer you bought the refrigerator from. Be ready to
quote the model number, the 9-digit PNC and 8-digit serial number, which is stated on the label inside
the refrigerator compartment.
WHAT TO DO
Ensure that the crisper is not over packed.
If crisper bin interferes with the door bins, remove door bins before
removing crisper.
Position cabinet so that the door can be fully opened.
Adjust temperature to a warmer setting.
WHAT TO DO
Ensure that the Ice Maker is switched on at the user interface refer to
"About the User Interface" for details.
Ensure water tank is full and contains clean water (if liquids other than
clean water have been used, call Electrolux Customer Care).
Ensure water tank is securely pushed into pump housing.
If the freezer compartment is too warm, refer to "freezer is too warm"
then wait 24 hours for the freezer to reach ideal temperature.
Turn the unit off at the mains and leave for 2 minutes then turn the
appliance back on (this will reset the icemaker unit). Check for ice
production after 24 hours.
Check that there is no obstruction under the ice maker and ensure
the ice bin is fitted correctly.
Cover food to ensure ice does not absorb foreign odours.
Interior of appliance or ice bin may require cleaning, refer to
"Cleaning your refrigerator".
Discard stale ice monthly and allow ice maker to produce a fresh supply.