Cleaning And Storage; Troubleshooting; Product Specifications - Honeywell COMFORT TEMP HCE641 Series Operating And Safety Instructions Manual

SAFETY FEATURES
The Honeywell ComfortTemp™ Ceramic Heater is equipped with several devices and features for added protection:
• A 360° tip-over switch that disables the heater if it is tipped in any direction.
• A high temperature safety sensor prevents overheating.
• A thermal cut-off fuse that will permanently shut down the heater should it operate at a higher than
normal temperature.
• Built using a high temperature plastic and has a cool to touch housing and handle.
• Thermal insulated wiring for heat resistance and reinforced wire connections to help protect against
loose connections.
• A SafeGuard® Auto Shut-Off feature. If used, this feature is designed to automatically
shut the heater off after 8 hours of continuous use.
• The HCE646 Series models have a SafeGuard® Motion Sensor that shuts the heater off if an object
gets too close to the motion sensor.

CLEANING AND STORAGE

It is recommended that the Honeywell ComfortTemp™ Ceramic Heater be cleaned at least once a month and
before off-season storage.
• Turn Off ( ). Allow unit to cool for 10 minutes. The heater fan will continue during this cool down phase
and unplug heater.
• Use a dry cloth only to clean the external surfaces of the heater. DO NOT USE WATER, WAXES, POLISHES
OR ANY CHEMICAL SOLUTION.
• Before storing, clean the Ceramic Heater using the above-mentioned steps. Wrap the cord around the unit.
Place in its original box and store it in a cool, dry place.
• This heater does not disassemble.

TROUBLESHOOTING

Problem
If your Honeywell ComfortTemp™
Ceramic Heater shuts off
unexpectedly or fails to operate,
one of your heater safety features
may have been activated to
prevent overheating.

PRODUCT SPECIFICATIONS

Model(s)
HCE641 Series
HCE646 Series
Solution
• Be sure heater is plugged in and that the electrical outlet is working.
• Check for any obstructions. If you find an obstruction, turn the heater
OFF ( ) and unplug it.
• Allow the heater to cool completely, then remove the obstruction. Wait at
least 10 minutes, then re-plug the heater in and follow the OPERATION
instructions.
Unit Dims
7.9" L x 7.9" W x 23.4" H
7.9" L x 7.9" W x 23.4" H
Amps Unit Voltage
12.5 120V, 60Hz
12.5 120V, 60Hz
6
Max Watts Max BTUs
1500 5118
1500 5118