Specifications - Makita HR3540C Instruction Manual

ENGLISH (Original instructions)

SPECIFICATIONS

Capacities
No load speed (min
Blows per minute
Overall length
• Due to our continuing programme of research and development, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for hammer drilling in brick, con-
crete and stone as well as for chiselling work.
Power supply
The tool should be connected only to a power supply
of the same voltage as indicated on the nameplate,
and can only be operated on single-phase AC supply.
They are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets
without earth wire.
For Model HR3540C
Noise
The typical A-weighted noise level determined accord-
ing to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Wear ear protection
Vibration
The vibration total value (tri-axial vector sum) deter-
mined according to EN60745:
Work mode : chiseling function
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Work mode : hammer drilling into concrete
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Work mode : drilling into metal
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Model
Concrete Tungsten-carbide
tipped bit
Core bit
Steel
Wood
-1
)
Net weight
Safety class
) : 93 dB(A)
pA
) : 104 dB(A)
WA
2
) : 12.5 m/s
h,CHeq
2
2
) : 18.0 m/s
h,HD
2
2
) : 2.5 m/s
h,D
2
HR3540C
5.2 kg
For Model HR3541FC
Noise
The typical A-weighted noise level determined accord-
ing to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Wear ear protection
Vibration
The vibration total value (tri-axial vector sum) deter-
mined according to EN60745:
Work mode : chiseling function
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Work mode : hammer drilling into concrete
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Work mode : drilling into metal
Vibration emission (a
Uncertainty (K) : 1.5 m/s
NOTE: The declared vibration emission value has
been measured in accordance with the standard test
method and may be used for comparing one tool with
another.
NOTE: The declared vibration emission value
may also be used in a preliminary assessment of
exposure.
WARNING:
The vibration emission during actual
use of the power tool can differ from the declared
emission value depending on the ways in which the
tool is used.
WARNING:
Be sure to identify safety measures
to protect the operator that are based on an estima-
tion of exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it is
running idle in addition to the trigger time).
5 ENGLISH
HR3541FC
35 mm
90 mm
13 mm
32 mm
315 - 630
1,650 - 3,300
439 mm
5.6 kg
/II
) : 91 dB(A)
pA
) : 102 dB(A)
WA
2
) : 9.0 m/s
h,CHeq
2
2
) : 11.0 m/s
h,HD
2
2
) : 2.5 m/s or less
h,D
2