Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for U-Line H-1630
Summary of Contents for U-Line H-1630
- Page 1 H-1630 1-800-295-5510 uline.com FLOOR CLEANING MACHINE PAGE 1 OF 7 0421 IH-1630...
- Page 2 IMPORTANT SAFEGUARDS When using an electrical appliance, basic precautions • Do not unplug by pulling on cord. To unplug, grasp should always be followed, including the following: the plug, not the cord. READ ALL INSTRUCTIONS BEFORE USING THIS FLOOR • Do not handle the plug or floor machine with wet CLEANING MACHINE.
- Page 3 IMPORTANT SAFEGUARDS CONTINUED DANGER For floor finishing machines rated 150–250 volts: If the machine is provided with an attachment plug Improper connection of an equipment-grounding cap as shown in Figure 3, it is intended for use on a 240 conductor can result in risk of electric shock. Check volt (nominal) circuit.
- Page 4 HOW TO REMOVE MACHINE FROM SHIPPING CARTON 1. Lift up on handle to 2. Move upper handle forward to expose 3. Remove the wing release lock. wing nuts and angle bracket. nuts and bolts from both upper and lower handle. Discard the angle bracket.
- Page 5 IMPORTANT SAFEGUARDS CONTINUED BRUSH AND PAD DRIVER INSTALLATION HANDLE ADJUSTMENT The handle can be adjusted to any desired work CAUTION: Disconnect the power cord from the position by simply pushing up on the handle lock. (See electrical outlet before installing a brush or pad Figure 6) Move the handle to the desired position, then driver.
- Page 6 IMPORTANT SAFEGUARDS CONTINUED CONTROLS GUIDELINES FOR OPERATION • Your floor machine is a very sensitive, powerful unit. ON/OFF POWER SWITCH TRIGGERS When in operation, it should be guided gradually The ON/OFF switch is conveniently located in the form of and smoothly without sudden or rough motions. You dual triggers underneath the handle grips.
- Page 7 IMPORTANT SAFEGUARDS CONTINUED CORD STORAGE CLEAN UP AND STORAGE When not in use, loosely wind the power cord around After being used, your floor machine can be wiped the cord storage hook on the handle shaft and both of clean with a soft, damp cloth and should be stored in a the handle grips.
Need help?
Do you have a question about the H-1630 and is the answer not in the manual?
Questions and answers