Assembly - CARDIOSTRONG BX40 Assembly And Operating Instructions Manual

2.3

Assembly

Before assembly, take a close look at the individual assembly steps shown and carry out the assembly
in the order given.
NOTICE
L
First loosely screw all parts together and check that they fit properly. Tighten the screws using
the tool only when you are instructed to do so.
Step 1: Assembly of the console mast and the front and rear base foot
1. Slide the console mast cover (60) on the console mast (2). Make sure that the cover points in the
correct direction; see image. Slide the cable harness (80) from below up through the console
mast. During assembly of the console mast on the frame, make sure that the cable harness does
not get stuck or damaged.
2. Mount the console mast on the frame with five screws (5/16"x 3/4") (32), four washers (5/16)
(33), five spring rings
(5/16) (35) and one spring
washer (5/16) (34). Allow
the console mast cover
(60) to lock on the frame.
3. Mount the front (4) and
rear base foot (5) with four
screws (5/16" x 3/4") (32),
four spring rings (5/16)
(35) and four washers
(5/16)(33).
Required tool: 6mm Allen
wrench (87).
14
BX40