Connecting To Pc; Pc With Ethernet Adapter - D-Link DVG-5402G User Manual

DVG-5402G/GF Wireless AC1200 MU-MIMO Dual Band
Gigabit Router with Fiber WAN Port, 3G/LTE Support, 2 FXS
Ports, and USB Port
User Manual

Connecting to PC

PC with Ethernet Adapter

1. Connect an Ethernet cable between any of LAN ports located on the back panel of the router
and the Ethernet port of your PC.
2. To connect the device to a fiber optic line: connect your SFP transceiver to the SFP port,
then connect the fiber optic cable to the SFP transceiver.
3. To connect via USB modem: сonnect your USB modem to the USB port
back panel of the router.
!
In some cases you will need to reboot the router after connection of the USB modem.
4. To connect the device to an Ethernet line: please connect the router to the ISP's Ethernet
line only after setting the WAN port and creating the Internet connection (see the Initial
Configuration Wizard section, page 50).
5. Connect a phone cable between an FXS port of the router and the phone.
6. Connect the power cord to the power connector port on the back panel of the router, then
plug the power adapter into an electrical outlet or power strip.
7. Turn on the router by pressing the ON/OFF button on its back panel.
Then make sure that your PC is configured to obtain an IP address automatically (as DHCP client).
7 It is recommended to use a USB extension cable to connect a USB modem to the router.
Page 25 of 311
Installation and Connection
7 located on the