Miele KWT 6322 UG Operating And Installation Instructions page 8

IMPORTANT SAFETY INSTRUCTIONS
– Contact Miele Technical Service.

The more coolant there is in a wine conditioning unit, the larger
the room it should be installed in. In the event of a leakage, if the
wine conditioning is in a small room, there is the danger of com-
bustible gases building up. For every 0.38 oz (11 g) of coolant at
least 35.3 cubic feet (1 m
coolant in the wine conditioning unit is stated on the data plate in-
side the wine conditioning unit.

To avoid the risk of damage to the wine conditioning unit, make
sure that the connection data (fuse rating, frequency and voltage) on
the data plate corresponds to the household supply.
Check that this is the case before connecting the wine conditioning
unit. Consult a qualified electrician if in any doubt.

The electrical safety of the wine conditioning unit can only be
guaranteed when correctly grounded. It is essential that this stan-
dard safety requirement is met. If in any doubt please have the elec-
trical installation tested by a qualified electrician.

Reliable and safe operation of the wine conditioning unit can only
be guaranteed if it is connected to the power supply.

Do not connect the appliance to the electrical supply with a power
bar or extension cord. These are a fire hazard and do not guarantee
the required safety of the appliance.

If moisture gets into electrical components or into the power cord,
it could cause a short circuit. Therefore, do not operate the wine
conditioning in areas where there may be moisture or splashing wa-
ter (e.g., garages, laundry rooms).

This wine conditioning unit must not be used in a non-stationary
location (e.g. on a ship).

Before installation and use check the wine conditioning unit for
any visible damage. Do not operate or install a damaged appliance.
8
3
) of room space is required. The amount of