Installation - Zanussi ZIT64X User Manual

Problem
and a number come on.
comes on.
If you tried the above solutions and cannot re-
pair the problem, speak to your dealer or the
customer service. Give the data from the rating
plate, three digit letter code for the glass ce-
ramic (it is in the corner of the glass surface)
and an error message that comes on.

Installation

Warning! Refer to the Safety chapters.
Before the installation
Before the installation of the appliance, record
the information below from the rating plate. The
rating plate is on the bottom of the appliance
casing.
• Model ...........................
• PNC .............................
• Serial number ....................
Built-in appliances
• Only use the built-in appliances after you as-
semble the appliance into correct built-in
26
Possible cause
There is an error in the appliance.
There is an error in the appliance
because a cookware boils dry.
The overheating protection for the
cooking zones and the Automatic
Switch Off operate.
Make sure, you operated the appliance correct-
ly. If not the servicing by a customer service
technician or dealer will not be free of charge,
also during the warranty period. The instruc-
tions about the customer service and condi-
tions of guarantee are in the guarantee booklet.
Connection cable
• The appliance is supplied with the connec-
• Replace the damaged mains cable with a
Disconnect the appliance from the
electrical supply for some time.
Disconnect the fuse from the elec-
trical system of the house. Connect
it again. If
speak to the service centre.
Deactivate the appliance. Remove
the hot cookware. After, approxi-
mately 30 seconds, activate the
cooking zone again. If the cook-
ware was the problem, the error
message goes out of the display,
but the residual heat indicator can
stay. Let the cookware become
sufficiently cool and refer to
"Cookware for the induction cook-
ing zone" to see if your cookware
is compatible with the appliance.
units and work surfaces that align to the
standards.
tion cable.
special cable (type H05BB-F Tmax 90°C; or
higher). Speak to your local Service Centre.
Remedy
comes on again,
www.zanussi.com