Advertisement
Table of Contents
PUMP
Dual Pump Controller Installation and
Operating Instructions
DOC: DPC 30010
CONTROL
PUMP 1
PUMP 2
POWER
AUTO
AUTO
ON
LEVEL
ALARM
OFF
OFF
Steady - High Level
Flash - Low Level
MUTE/
MAN
MAN
RESET
Press and hold
for 3 secs to reset
PUMP ON
PUMP ON
Dual Pump
FAULT
FAULT
Controller
Steady - Overload
Steady - Overload
Flash - Prime Loss
Flash - Prime Loss
DANGER - HIGH VOLTAGE
DO NOT REMOVE COVER. AUTHORIZED PERSONS ONLY
REVISED: 220210
Advertisement
Table of Contents
Related Manuals for Matelec FPC-30010
Summary of Contents for Matelec FPC-30010
- Page 1 PUMP CONTROL Dual Pump Controller Installation and Operating Instructions PUMP 1 PUMP 2 POWER AUTO AUTO LEVEL ALARM Steady - High Level Flash - Low Level MUTE/ RESET Press and hold for 3 secs to reset PUMP ON PUMP ON Dual Pump FAULT FAULT...
-
Page 2: Circuit Diagram
WELCOME TO DUAL PUMP CONTROL Your Dual Pump Controller reflects the superior quality and attention to detail in design, engineering and manufacturing that has distinguished MATelec Products for decades. The controller incorporates the very latest in micro- processor technology, ensuring you, the owner/operator, of many years of functional, reliable and ‘user friendly’... - Page 3 MOUNTING 1. Controller enclosure must be FRONT VIEW SIDE VIEW mounted in a vertical position. 2. Ensure mounting method does not compromise enclosure weather proof rating. PUMP 1 PUMP 2 POWER AUTO AUTO 3. Ensure access to main isolator LEVEL ALARM Steady - High Level Flash - Low Level...
- Page 4 This controller can perfor m control functions for most Dual Pump pumping applications. It is more than likely that the control parameters have already been set up for your particular application however; hereunder you will find details of the set up and configuration options. There are 6 DIP switches located on the lower side of the control module, which allow s for selecting “mode”...
- Page 5 Table A Input 1 Input 2 Input 3 Input 4 Pump Alarm Low Level Pump Stop Pump Start High Level State Closed Open/Closed Open Open Closed Open/Closed Closed Open Closed Open/Closed Closed Closed Both on High level (after timeout) Closed Open/Closed Open Closed...
- Page 6 Maximum Run and Alternation Mode With DIP Switch 3 set to “Off” the unit will alternate as usual each time a pump start condition occurs. Additionally, the controller will automatically alternate pump duty if a pump has been running continuously for 30 minutes (maximum run timer) Setting this DIP switch to “On”...
- Page 7 PUMP 1 PUMP 2 POWER AUTO AUTO LEVEL ALARM Steady - High Level Flash - Low Level MUTE/ RESET Press and hold for 3 secs to reset PUMP ON PUMP ON Dual Pump FAULT FAULT Controller Steady - Overload Steady - Overload Flash - Prime Loss Flash - Prime Loss DANGER - HIGH VOLTAGE...
-
Page 8: Push Buttons
A pump fault/overload has occured FLASHING The pump is set to Manual Pumping Mode A prime loss fault has occured INSTALLATION DATE: DISTRIBUTED BY: SERIAL NUMBER: MANUFACTURED BY MATelec AUSTRALIA EMAIL: info@matelecaustralia.com.au MATelec reserves the right to alter technical specifications without notice...
Need help?
Do you have a question about the FPC-30010 and is the answer not in the manual?
Questions and answers