Remote switch setting
• Remote controller address setting (SW3)
This switch can be used when group control system. Set the remote controller address in the
1,2,-,15 order.
SW3
0
1—15
Jumper wire setting
• JM1 and JM2 setting prohibited
• Fan delay setting (JM3)
When the indoor unit is stopped while operating in conjunction with auxiliary heater, the indoor
unit fan operation will continue for one minute.
Connect
Disconnect
9-1. Models: ARXG45KHTA and ARXG54KHTA
Remote controller address
JM3
SW state
Single
JM state
Disable
Enable
- 25 -
Factory setting
♦
Factory setting
♦
9. Function settings