Wall Installation - Conrad Electronic 84 09 69 Operating Instructions Manual

6. Wall Installation

• Remove the wall holder from the rear side of the oral irrigator.
• Look for an appropriate location for installing the wall holder.
Observe a top distance of 12cm and a lateral distance of 6cm.
• Mount the wall holder onto the wall as shown in figure 2. For
this, use appropriate dowels, if necessary.
Make sure not to damage any electrical cables,
water or gas lines when drilling! Danger!
Drilling holes into tiles of a rented apartment might
involve claim for compensation by your landlord. If in
doubt, consult your landlord before drilling holes into
the tiles to mount the wall holder.
• Insert the oral irrigator into the wall holder and push it down
until it locks into place.
• Screw the small screw into the respective aperture to fasten
the oral irrigator to the wall holder. Thus, it cannot loosen from
the wall holder.
25