I Cannot Register The Network Media Receiver At The Computer; The Computer Does Not Show Up On The "Select A Server; I Can No Longer Connect To A Computer After Performing A Hard Disk Drive Recovery On The Computer - Sony VGP-MR200 Operating Instructions Manual

I cannot register the Network Media Receiver at the computer

c Check whether the network connections are established correctly.
Check the following items:
• If the Network Media Receiver is connected directly to a single computer, is the crossover
cable being used? (page 27)
• Are the hub and router receiving power? (For details, see the manual of the respective device.)
• Was the router turned on before the Network Media Receiver was turned on? (page 38)
• Are the Network Media Receiver and the hub or router connected correctly with network
cables? (page 25)
• Is the IP address allocation method for the Network Media Receiver selected correctly for the
network environment? (page 34)

The computer does not show up on the "Select a server..."

screen
c Press the OPTIONS button on the remote control, select "Refresh", and press the SELECT
button (page 40). It may take some time for the computer name to appear in the list.
c Verify that the server software has been started on the computer.
Start the software as appropriate for your computer.
If you are using VAIO Media, refer to the VAIO Media Help.
c For video-related functions to be available, a user must be logged on to the computer. Starting up
the computer without logging in is not adequate.
I can no longer connect to a computer after performing a hard
disk drive recovery on the computer
c Perform the steps in "7 Configure settings at the computer" (page 35) again.
68