Haier HW150-BP14986E User Manual page 30

10-Installation
10.6 Drain Water Connection
Fix the water drain hose properly to the piping. The hose has to reach at one point a
height between 80 and 100 cm above the appliance bottom line! If possible keep always
drain hose fi xed to the clip at the appliance back.
WARNING!
Use only the supplied hose set for the connection.
Never reuse old hose sets!
Only connect to cold water supply.
Before connection, check whether the water is clean and clear.
10-9
10-10
10-11
CAUTION!
The drain hose should not be submerged in water and should be securely fixed and
leak-free. If the drain hose is placed on the ground or if the pipe is at a height of less
than 80 cm, the washing machine will continuously drain while being filled (self-si-
phoning).
Drain hose is not to be extended. If necessary contact after sales service.
30
Following connections are possible:
10.6.1 Drain hose to sink
Hang the drain hose with the U-support over the
edge of a sink with adequate size (Fig. 10-9).
Protect the U-support suffi ciently against slip-
ping.
10.6.2 Drain hose to waste water connection
The internal diameter of the stand pipe with
vent-hole must be minimum 40 mm.
Put the drain hose for approx. 80 mm in the
wastewater pipe.
Attach the U-support and secure it suffi ciently
(Fig. 10-10).
10.6.3 Drain hose to sink connection
The junction must lie above the siphon
A spigot connection is usually closed by a pad (A).
That must be removed to prevent any disfunc-
tion (Fig. 10-11).
Secure the drain hose with a clamp.
EN