10-Installation - Haier HW150-BP14986E User Manual

10-Installation

10.1 Preparation
▶ Take the appliance out of the packaging.
▶ Remove all packaging material including polystyrene base, keep them out of childrens
reach. While opening the package, water drops may be seen on plastic bag and port-
hole. This normal phenomenon results from water tests in the factory.
Note: Packaging disposal
Keep all packaging materials out of children´s reach and dispose them in an environ-
mentally friendly manner.
10-1
noise redu-
10-3
2x
,
1x
1x
Note: Noise reduction pad
Noise reduction pad is optional , could help to reduce noise , please assemble it or not
according to your own demand. .
10-4
10-6
./0 5
C
D
E
28
10.2 Install metal board
./0 1
10-2
1. Tilt back the appliance (Fig. 10.1).
2.
./0 2
3. Take out the noise reduction pads and remove
1/. 4
10.3 Dismantle the transportation bolts
10-5
.
The transportation bolts are designed for clamping
anti-vibration components inside the appliance during
transportation to prevent inner damage.
A
1. Remove the 4 transportation bolts (A) on the rear
B
2.
10-7
3.
F
Get the metal board from the top of the
packaging foam and install to the bottom of
the appliance, then fi x the metal board with
four screws (Fig. 10.2).
the double-sided adhesive protective film; place
the noise reduction pads under the washing ma-
chine cabinet as shown in Figure 10.3.(two longer
pads in position 1 and 3, two shorter pads in
position 2 and 4). Finally set the machine upright
again.
side and take out plastic spacers (B) from inner
side of the machine (Fig. 10. 4 and 10.5).
Remove the strengthen pieces screws (C), then re-
move the strengthen pieces (D) and take out pack-
ing rods (E) innerside of the appliance (Fig. 10.6).
Fill left holes with blanking plugs (F) (Fig. 10.7).
EN