Managing The Hub House Number - rako WK Instruction Manual

4
Step 1 - ​ W elcome page, select "Next to begin setup".
Step 2 - ​ S et a Password, this will be used to login to the webpages. It will also be the
password used to login to the App if a password is needed.
Step 3 - ​ S ets the House number of the HUB and therefore system. This should be set to
match the Rasoft Pro project file as defined in the "New Project Wizard".
Step 4 - ​ S elect "Finish" to complete setup.

3.2 Managing the HUB House number

Leaving the HUB on the default House address of 1 is strongly discouraged. Leaving
the House number as 1 drastically increases the likelihood of interface from nearby
Rako systems.
The HUB always has a ​ d efault House Address of 1 ​ i f has not been setup before​ . ​ When
beginning any programming using the HUB it is important to first ensure the House is set the
same as the address used when creating the Project File.
The change the House number if the HUB has already been set up as described in 3.2 see
below:
WK-HUB Manual Version 1.0.0