Installing Hook - Makita TD111D Instruction Manual

Changing the impact force
Fig.7: 1. Hard 2. Soft 3.
steps 5. Button
changes in three steps.
Impact force grade displayed
on panel
Hard
Soft
NOTE:
impact force and speed are the same as hard mode.
NOTE:
NOTE:
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Installing or removing driver bit/
socket bit
Optional accessory
Fig.8
For tool with shallow driver bit hole
Use only these type of driver
bit. Follow the procedure
1. (Note) Bit-piece is not
necessary.
For tool with deep driver bit hole
bits, follow the procedure 1.
bits, follow the procedure 2.
(Note) Bit-piece is necessary
for installing the bit.
4. Changed in three
driving screws with good control.
In this mode, the tool drives a screw with low-speed
trigger, the impact force can be changed.
Maximum blows
-1
3,900 min
speed are desired.
-1
1,600 min
avoid screw thread breakage.
-1
3,900 min
control.
tion of the arrow and insert the driver bit into the
sleeve as far as it will go.
Fig.9: 1. Driver bit 2. Sleeve
2.
of the arrow and insert the bit-piece and driver bit into
inserted into the sleeve with its pointed end facing in.
Fig.10: 1. Driver bit 2. Bit-piece 3. Sleeve
of the arrow and pull the driver bit out.
NOTE: If the driver bit is not inserted deep enough into the
sleeve, the sleeve will not return to its original position and
the driver bit will not be secured. In this case, try re-insert-
ing the bit according to the instructions above.
NOTE:

Installing hook

Fig.11: 1. Groove 2. Hook 3. Screw
the hook, insert it into a groove in the tool housing on
loosen the screw and then take it out.
7 ENGLISH
Purpose Example of application
tightening bolts.
ening small screws such as M6.
-
-
-