Advertisement
SOFTWARE INTRODUCTION
H.
Channel type selection: front audio,
rear audio, center audio, subwoofer
audio.
I.
Channel volume: The volume can be
adjusted by sliding left and right, the
volume range:0~60.
J.
Delay setting: Slide the dots left and
right to set the delay value. Delay
range:millisecond
range:0.000~20.000; cm range:0~692;
inch range:0~273.
K.
Mute:Click the speaker button to
mute.
L.
Channel phase: Forward and reverse
switching.
M.
Channel joint debugging settings:
Click the joint debugging button and
the joint debugging window will pop
up to select the joint debugging
method.
3.
Mixer Interface
N.
Bluetooth/USB-L, Bluetooth/USB-R and
4 analog, and mixing options and
adjustment,adjustment range:0~100.
P
9 EN
Q
4.
EQ Interface
Corresponding to the adjustment of
the output channel EQ curve (gain, Q
value and frequency); reset
equalization, pass-through
equalization or parametric
equalization operation settings.
O.
EQ display: Edit the display area.
P.
Reset equalization, parametric
equalization, and pass-through
equalization settings: Click [Reset] to
restore the parameters of the 15-short
equalizer to the original factory
pass-through mode (equalizer
frequency, Q value and gain return
to their initial values).
When there is channel adjustment,
click [PEQ] to switch between [PEQ]
and [GEQ] modes.
Q.
HPF and LPF adjustment:
Frequency range:20Hz~20.0kHz.
Channel type: Choose from Link-Rill,
Butter-W and Bessel.
Slop selection: 6dB/Oct, 12dB/Oct,
18dB/Oct, 24dB/Oct, 30dB/Oct,
36dB/Oct, 42dB/Oct, 48dB/Oct and
OFF can be selected.
EQ
O
R
Advertisement
