Online Registration; Control Elements And Connectors; Mono Channels - Behringer Eurorack PRO RX1202FX User Manual

EURORACK PRO RX1202FX
Never connect the EURORACK to the power supply
unit when the latter is connected to the mains!
First connect the power supply unit to the console,
then connect the power supply unit to the mains.
Please make sure that all units have a proper
ground connection. For your own safety, never
remove or disable the ground conductor from the
unit or on the AC power cord. The unit should always
be connected to a mains socket outlet with a
protective earthing connection.
When installing the product, ensure the appliance
coupler or power cord is easily accessible for
disconnecting the unit from mains.

1.3.3 Online registration

Please do remember to register your new BEHRINGER equipment
right after your purchase by visiting www.behringer.com
(alternatively www.behringer.de) and kindly read the terms and
conditions of our warranty carefully.
Should your BEHRINGER product malfunction, our goal is to
have it repaired as quickly as possible. To arrange for warranty
service, please contact the retailer from whom the equipment
was purchased. Should your BEHRINGER dealer not be located
in your vicinity, you may directly contact one of our subsidiaries.
Corresponding contact information is included in the original
equipment packaging (Global Contact Information/European
Contact Information). Should your country not be listed, please
contact the distributor nearest you. A list of distributors can be
found in the support area of our website (www.behringer.com).
Registering your purchase and equipment with us helps us
process your repair claims quicker and more efficiently.
Thank you for your cooperation!
6
This chapter describes the various control elements of your
mixing console. All controls, switches and connectors will be
discussed in detail.
MIC
Each mono input channel offers a balanced microphone input
via the XLR connector and also features a switchable +48 V
phantom power supply for condenser microphones.
LINE IN
Each mono input also features a balanced line input on a 1/4"
connector. Unbalanced devices (mono connectors) can also be
connected to these inputs.
INSERT
The INSERT connector is input and output at the same time.
This allows you to insert external signal processors
(compressors, gate, etc.) in the channel. The signal retrieval
occurs after the TRIM and is practically a diversion of the signal.
The input signal of the connected signal processor is diverted,
processed and led back to the channel for further processing.
TRIM
Use the TRIM control to adjust the input gain. This control
should always be turned fully counterclockwise whenever you
connect or disconnect a signal source to one of the inputs.
The scale has 2 different value ranges: the first value range
(+10 to +60 dB) refers to the MIC input and shows the
amplification for the signals fed in there.

2. CONTROL ELEMENTS AND CONNECTORS

2. CONTROL ELEMENTS AND
CONNECTORS

2.1 Mono channels

Fig. 2.1: Connectors and controls on the mono channels
Please mute your playback system before you
activate the phantom power supply to prevent
switch-on thumps being
loudspeakers. Please also note the instructions in
chapter 2.4 "Main section".
Please remember that you can only use either the
microphone or the line input of a channel at any
one time. You can never use both simultaneously!
directed to your