Advertisement
Quick Links
Impinj R705 Portal Gateway Reader Installation and Operations Guide
Impinj R705 Portal Gateway Reader
Installation and Operations Guide
Version 0.2
Copyright © 2012 - 2020 Impinj, Inc. All rights reserved
http://www.impinj.com
Impinj, Octane, Speedway, xSpan and xArray are either registered trademarks or trademarks of Impinj, Inc. Visit
www.impinj.com/trademarks for additional information about Impinj trade- marks.
Version 0.1
1
Advertisement
Related Manuals for impinj R705
Summary of Contents for impinj R705
- Page 1 Installation and Operations Guide Version 0.2 Copyright © 2012 - 2020 Impinj, Inc. All rights reserved http://www.impinj.com Impinj, Octane, Speedway, xSpan and xArray are either registered trademarks or trademarks of Impinj, Inc. Visit www.impinj.com/trademarks for additional information about Impinj trade- marks. Version 0.1...
- Page 2 Impinj R705 Portal Gateway Reader Installation and Operations Guide Requirements, Certifications, and Warnings Products Covered by this Guide This guide pertains to Impinj R705 Portal Gateways with the following part numbers: Gateway Communication Code Part Number R705 FCC and Global...
- Page 3 RFID devices designed for use throughout the EEA must have a maximum radiated transmit power of 2W ERP in the frequency range of 865.6-867.6 MHz and 4W ERP for 916.1-918.9MHz. For other EEA restrictions on RFID device use, refer to the Impinj Declaration of Conformity (DoC) located at support.impinj.com.
- Page 4 Sealing: IP50 Simplified EU Declaration of Conformity Hereby, Impinj, Inc., declares that the radio equipment type IPJ-R705-EU1, IPJ-R705-EU2 is in compliance with Directive 2014/53/EU, EMC Directive 2014/30/EU, and RoHS 2015/863/EU. The full text of the EU declaration of conformity is available at the following internet address: https://support.impinj.com/hc/en-us/articles/360005324979-EU-Declaration-of-Conformity...
- Page 5 Introduction The Impinj R705 portal gateway is sold to product companies, which embed the device within their product providing overall enclosure and device control. The device does not include an enclosure and is not intended for sell to the general public.
- Page 6 Impinj R705 Portal Gateway Reader Installation and Operations Guide The reader is located the side of the ground plane opposite the antenna elements. The reader features multiple interfaces. Ethernet network interface, USB ports and GPIO block are located on the end of the reader. The Ethernet network jack is the only interface that the customer is required to access.
- Page 7 After manually setting the power source to PoE+, you must reboot the gateway so that the change can take effect. Please refer to the Impinj RShell Reference Manual for more details. The selected power source will persist across reboots but will need to be configured again after a full system reset.
- Page 8 Default Network Settings Settings Description Hostname impinj-xx-xx-xx, where xx-xx-xx is the last three bytes of the gateway’s MAC address (which is printed on the label attached to the gateway case). DHCP Enabled. The gateway also reports its hostname to the DHCP server.
- Page 9 3. Select one of the available regions from the dropdown list. Note: If you do not see your country or region listed, contact Impinj to find out about current regulatory approval status. 4. On the Change Regulatory Region dialog, click Reboot. When you change the operating region, the change does not take effect until the next reboot.
-
Page 10: Upgrading The Firmware
1. Obtain the firmware upgrade file from the Impinj support web site, http://support.impinj.com. The upgrade file extension is .upgx 2. Place the upgrade file on a server (http or sftp) that can be accessed by the Impinj R705 gateway you are upgrading. - Page 11 If the firmware upgrade process fails, the Power LED will blink red. If this happens, remove the USB drive, reboot the Impinj R705 gateway, and check the status.log file for the reason of the failure.
-
Page 12: Document Revision History
Copyright © 2020, Impinj, Inc. All rights reserved. Impinj gives no representation or warranty, express or implied, for accuracy or reliability of infor- mation in this document. Impinj reserves the right to change its products and services and this information at any time without notice. - Page 13 Impinj R705 Portal Gateway Reader Installation and Operations Guide Impinj, GrandPrix ™, Indy ®, Monza ®, Octane ™, QT ®, Speedway ®, STP ™, True3D ™, xArray ®, and xSpan ® are trademarks or registered trademarks of Impinj, Inc. All other product or service names are trademarks of their respective companies.
Need help?
Do you have a question about the R705 and is the answer not in the manual?
Questions and answers