Kenwood CM200 Series Instructions Manual page 4

to make coffee
1 Lift the lid using the tab d at the
front of the coffee maker.
2 Fill the tank with the desired amount
of water. The water level must be
between the 2 and 4 cup marks.
Do not fill above the MAX level.
Use cold water. We recommend
l
using filtered water as it reduces
limescale and prolongs the life of
your coffee maker. Never use warm
or fizzy water.
3 Ensure the filter holder is positioned
correctly.
4 Fit either the permanent filter
supplied or a paper filter into the
filter holder. Add the coffee using
the spoon supplied (approximately
1 level spoon (7g) per cup to taste).
5 Close the lid and put the carafe on
the hotplate.
6 Plug in and switch on.
7 Don't remove the carafe until
brewing has finished. When the
carafe is empty, switch off and
unplug the appliance.
Your coffee maker will keep the
l
coffee warm and then switch off
after approximately 40 minutes. The
indicator light will go out when the
keep warm stops. If you want to
continue keeping the coffee warm
then switch the coffee maker off
then back on, the coffee will then
keep warm for another 40 minutes.
If you have not used the appliance
l
for a while, run one full tank of
water (without coffee) through to
clean it out.
care & cleaning
Always switch off, unplug and allow
l
to cool before cleaning.
Don't wash parts in the dishwasher.
l
carafe and lid, filter holder
and permanent filter holder
Wash, then dry.
l
body
Wipe with a damp cloth, then dry.
l
Don't use abrasives - they'll scratch
the plastic and metal surfaces.
to descale
1 Buy a suitable descaler.
2 Descale the machine.
3 After descaling, run at least two
full tanks of water (without coffee)
through the coffee maker to clean it
out.
4 Wash the parts.
service and customer
care
If you experience any problems with
l
the operation of your appliance,
before requesting assistance visit
www.kenwoodworld.com.
Please note that your product
l
is covered by a warranty, which
complies with all legal provisions
concerning any existing warranty
and consumer rights in the country
where the product was purchased.
If your Kenwood product
l
malfunctions or you find any
defects, please send it or bring
it to an authorised KENWOOD
Service Centre. To find up to date
details of your nearest authorised
KENWOOD Service centre visit
www.kenwoodworld.com or the
website specific to your Country.
Designed and engineered by
l
Kenwood in the UK.
Made in China.
l
4