Cleaning And Care - Silvercrest SHBS 600 A1 Operating Instructions Manual

Hair & beard trimmer
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 4

Cleaning and care

GB
IE
10
DANGER
Danger to life due to electric shock!
Pull the mains power adapter
the appliance.
Never touch the mains power adapter
plugging it in or unplugging it.
Always keep the mains power adapter
CAUTION
Possible damage to the appliance.
The hair and beard trimmer should never be immersed in water or other
liquids for cleaning, as the appliance is not waterproof. Doing this may
damage live parts (batteries).
Do not use aggressive or abrasive cleaning agents, as these may corrode
the surface of the casing.
Clean the housing only with a soft damp cloth and a mild detergent.
Switch the hair and beard trimmer off by pressing the ON/OFF switch
Disconnect the cable from the appliance and pull the mains power adapter
out of the power socket.
Remove any cutting length attachment (
Wash the cutting length attachment (
Dry the cutting length attachment (
Push the slide switch for the thinner attachment
tion 0 to move the thinner attachment
Press your thumb against the front of the cutting unit
holder (see Fig. D). Then remove the cutting unit
Use the cleaning brush supplied to remove any residual hair from the cutting
unit
.
Once you have completed cleaning, push the tab of the cutting unit
mounting opening on the appliance (see Fig. E).
Push the cutting unit back onto the appliance by pressing lightly from above until
it clicks into place (see Fig. F).
out of the power socket before cleaning
9
with wet hands, especially when
9
and the cable dry.
9
or
) from the appliance.
10
11
or
) under running water if required.
10
11
or
) thoroughly afterwards.
10
11
right as far as the stop to posi-
3
into its starting position.
2
to release it from its
from the appliance.
.
6
9
into the
SHBS 600 A1

Advertisement

Table of Contents
loading

This manual is also suitable for:

102827

Table of Contents