Figure 3 Steps 4 To 6 To Get Started With The Distance2Gol Demo Board - Infineon BGT24LTR11 Manual

Distance2GoL (Software-Controlled FMCW) low-power radar shield using
BGT24LTR11 for range detection and human tracking
Getting started
STEP 4
Download SW/HW package
• Open "
Infineon Toolbox
• Click on "
Distance2GoL Kit
• Follow the instructions
mentioned on the left tab
"
Getting Started
• Save the setup file and run it.
D2GL-HW-SW.exe
• Browse to the preferred
location to store the files.
Figure 3 Steps 4 to 6 to get started with the Distance2GoL demo board
Application Note
Optional
Connect board
". • Insert the micro-USB
cable into the Radar
". Baseboard XMC4700
"Debug" port.
".
• Insert the USB connector
into the PC's USB port.

If the device driver is not
recognized
Right-click on "My Computer"
Manage

Other devices

on "Unknown device"
Update Driver Software
Browse
Firmware_Software
XMC_Serial_Driver.
STEP 5
:
Device Manager

Right-click





page 9 of 32
STEP 6
Firmware update
• Download and install
SEGGER J-Link USB driver for
Windows:
www.segger.com/download
s/jlink/#J-
LinkSoftwareAndDocument
ationPack
• Connect board as
STEP 5
• Open
Infineon Toolbox 
Radar GUI  Device  Flash
Firmware.
• Select Device "
Distance2GoL /
" and select
Sense2GoL Pulse
"
D2GL_SC_FMCW.hex
Firmware
• Click on "
Flash Firmware
Optional
".
".
V1.0
2021-03-31