Lattice Semiconductor POWR607 User Manual page 11

6. Click on the File Name section and browse to the <Demo Dir>\project folder, select <Demo>.jed, and click
Open. 

Select appropriate JEDEC files of POWR607 and POWR6AT6
7. In Programmer, choose Design > Program, or click
Programming requires about 20-40 seconds. During programming, a pop-up "Programming XCF" appears. At the
end of programming, the Output console of Programmer should show "Operation: successful".
JTAG Cable Interface
This section describes how to connect and reprogram the evaluation board using a JTAG cable.
1. Connect external +5 V and GND power to pad locations J5 and J6.
2. Connect the JTAG cable between J3 header and the JTAG source.
3. Run Lattice Diamond Programmer to program the POWR607 board.
4. Follow the procedure of "USB Cable Interface" using Diamond Programmer, select Cable "LATTICE" and down-
load JEDEC files to selected devices.
POWR607/6AT6 Evaluation Board
This section describes the features of the POWR607/6AT6 evaluation board in detail.
Overview
The POWR607/6AT6 Evaluation Board is a complete development platform for the Lattice POWR607 mixed-signal
device. The board includes circuitry to emulate a processor/DSP interface, a USB program/power port, SMD and
thru-hole prototyping areas, and an expansion header to support test connections. A Power Manager II ispPAC-
POWR6AT6 is included and can be programmed to demonstrate power supply margin and trim applications. The
board is powered by a PC USB port and you may reprogram the board using Lattice Diamond Programmer. If no
USB port is available for your PC, the board can be modified such that it can be powered with an external power
supply and programmed with a JTAG cable (sold separately) from another JTAG source.
POWR607/6AT6 Evaluation Board
on the toolbar programming will start.
11