Table of Contents
Advertisement
Quick Links
TECHNICAL MANUAL
Safety, Operation, Parts & Service
Model:
744317
RENOVAIRE
WARNING: If incorrectly used this machine can cause severe injury. Those who
use and maintain this machine should be trained in its proper use, warned of its
dangers and should read the entire manual before attempting to set up, operate,
adjust or service the machine.
4130421 REV A
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Textron Jacobsen RENOVAIRE 744317
Summary of Contents for Textron Jacobsen RENOVAIRE 744317
- Page 1 TECHNICAL MANUAL Safety, Operation, Parts & Service Model: 744317 RENOVAIRE WARNING: If incorrectly used this machine can cause severe injury. Those who use and maintain this machine should be trained in its proper use, warned of its dangers and should read the entire manual before attempting to set up, operate, adjust or service the machine.
- Page 2 © 2003, TEXTRON INC...
-
Page 3: Table Of Contents
Jacobsen designs and builds its equipment to serve many years in a safe and productive manner. For longest life, use this machine only as directed in the manual, keep it in good repair and follow safety warnings and instructions. You'll always be glad you did. Jacobsen, a Textron Company One Bob Cat Lane Johnson Creek, WI 53038-0469... -
Page 4: Safety
Your safety and the safety of others is involved. Jacobsen, a Textron Company strongly warns Signal word definitions against, rejects and disclaims any modifications, add-on accessories or product alterations that are... -
Page 5: Setup
SET-UP RENOVAIRE GENERAL NOTE: FRONT, REAR, RIGHT HAND AND LEFT HAND REFERENCES BELOW ARE WITH RESPECT TO AN OPERATOR AT THE CONTROLS. SET-UP 1. Set Frame Assembly on blocks so that hitch end of frame is approximately 18" above ground. To prevent possible injury use an adequate lifting device or a minimum of two (2) men when placing main frame on blocks. -
Page 6: Operation / Transporting
OPERATION / TRANSPORTING RENOVAIRE OPERATION NOTE: When aerating in soft ground and full penetration is not desired, the depth may be NOTE: Failure to lubricate aerating wheels can controlled with the hydraulic system. cause serious damage to aerating wheels, bushings and axles. Never cross hard objects or surfaces (sidewalks, drives, stepping stones, etc.) with the tines down. -
Page 7: Service / Specifications
SERVICE / SPECIFICATIONS RENOVAIRE SERVICE When replacing any bolt, screw or other fastener, use only original equipment parts or parts of equivalent strength and material to prevent possible failure. 1. Thoroughly clean all tines inside and out when aerating is completed. A light coat of oil will prevent rust and insure proper coring and slicing the next time unit is put into service. -
Page 8: Aeration Tools
AERATION TOOLS RENOVAIRE 545364 - 1/2" Coring Tine Kit 545365 - 3/4" Coring Tine Kit Each kit consisting of 100 #515196 1/2" coring tines or 100 #515197 3/4" coring tines is for thorough aeration programs in the Spring and Fall. Soil cores up to 4"... -
Page 9: Dragmat
DRAGMAT RENOVAIRE 544518 - DRAGMAT When aerating a fairway, a DRAGMAT can be attached directly behind the Renovaire to break up the cores while aerating all in one quick easy opera- tion. Mat size: 12' wide x 10' long. -
Page 10: Hydraulic Hand Pump
HYDRAULIC HAND PUMP RENOVAIRE 546010 - Hydraulic Hand Pump 548812 - Seal and Gasket Kit For use on Renovaire when hydraulic lifting system Includes one each of items 1, 4, 5 and 12; two each on tractor is not used. There are three service kits of item 2;... -
Page 11: Parts Section
PARTS SECTION RENOVAIRE PARTS SECTION... -
Page 12: Frame Assembly
FRAME ASSEMBLY RENOVAIRE FIGURE 1 22 13 3 23 14 15 17 18... - Page 13 FRAME ASSEMBLY RENOVAIRE FIGURE 1 ITEM PART NO. DESCRIPTION ITEM PART NO. DESCRIPTION 548008 SCREW, HEX HD 1/2-20X1 4 515183 NUT, 1/2-20 548265 SEAL, OIL 548124 BEARING, TAPERED 385174 BEARING, CUP 515182 AXLE 548494 TUBE 548590 TIRE 515181 * 546009 TIRE AND WHEEL ASSY (INCLUDES ITEMS 2-9) 1-10 120310...
-
Page 14: Aerating Wheel
AERATING WHEEL RENOVAIRE FIGURE 2... - Page 15 AERATING WHEEL RENOVAIRE FIGURE 2 ITEM PART NO. DESCRIPTION ITEM PART NO. DESCRIPTION 306414 SCREW, HEX HD 3/8-16X1 24 306562 NUT, HEX, 3/8-16 120177 WASHER, LOCK, 3/8 515119 TRAY, WEIGHT 302600 SCREW, HEX 3/8-16X1-1/2 48 515118 SUPPORT, TRAY 515120 SUPPORT, TRAY 305134 NUT, HEX, JAM, 7/8-14 316954...
- Page 16 Equipment from Jacobsen, a Textron company, is built to exacting standards ensured by ISO 9001 and ISO 14001 registration at all our manufacturing locations. A worldwide dealer network and factory-trained technicians backed by Textron Parts Xpress provide reliable, high-quality product support.
Need help?
Do you have a question about the Jacobsen RENOVAIRE 744317 and is the answer not in the manual?
Questions and answers